Welcome to Railway Forum! | |
Thank you for finding your way to Railway Forum, a dedicated community for railway and train enthusiasts. There's a variety of forums, a wonderful gallery, and what's more, we are absolutely FREE. You are very welcome to join, take part in the discussion, and post your pictures!
|
|
|
Thread Tools |
#1
|
|||
|
|||
Hornby 9F tender wheels
Hi everyone, Merry christmas to you all!
My son has had a Hornby 9F given to him for Christmas and, whilst it is very well detailed and runs generally very smoothly there seems to be a problem when going over Peco setrack points. When going over the points forwards the centre axle on the tender rides up onto the points and sometimes derails the tender or at best causes the tender to jump. I've had a look at the tender wheels and there seems to be an awful lot of sideways play. The model has not been dropped or damaged so I'm wondering if there is a modification or new wheelset available that I could fit to cure the problem? Changing all the track is not an option really. |
#2
|
|||
|
|||
Hi there, only thing I can think of is glueing thin bits of plastic on the inside of the tender frame and/or putting washes on the axels to stop there being so much play in the wheels. Only other thing is to file the flanges off the center wheels or just take them off and hope he does,nt notice...
|
#4
|
|||
|
|||
The centre wheels don't make contact as you know and are there for cosmetic reasons only. I normally set my back to backs with a clock vernier at 14.6 mm
sometimes a little more, I've even read of some people using 14.9 mm. I find this more reliable than using a back to back gauge. You might find your example is a little tight on back to back. The wheels are quite easy to push in or gently ease outwards with a screw driver. Of course without a vernier your guesssing as to what the measurement is exactly. |
#5
|
|||
|
|||
Thanks for the advice, I'll check the measurements and try to stop them wobbling about so much. Happy new year to you all!
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|