| Welcome to Railway Forum! | |
 | Thank you for finding your way to Railway Forum, a dedicated community for railway and train enthusiasts. There's a variety of forums, a wonderful gallery, and what's more, we are absolutely FREE. You are very welcome to join, take part in the discussion, and post your pictures!
|
|
|||||||
 |
|
|
Thread Tools |
|
#1
8th January 2010, 06:14
|
|||
|
|||
|
Disaster !!!
Last night I run one of my 8Fs on my layout, I had got nothing else running and true enough this particular loco was one which I got hold of a long time ago and it was in a bad way, but I got it in my shed and managed to give it a overhaul and cleaned it up, but I dont run it as much as the others. So last night I thought I would give it a run, light engine round the layout and after about a couple of minutes It started making a "grating" noise AND THEN started smelling of burning and STOPPED !!! A complete failure !
 ,Looks like a major job !! Bloody hell it had to be one of my 8Fs didnt it !! 48111 
|
|
#2
8th January 2010, 09:53
|
||||
|
||||
|
What type of 8F one of the latest or a tender drive?
Jack
|
|
#3
8th January 2010, 12:00
|
|||
|
|||
|
Morning Jack, no mate one of the older models, I have had it quite a bit now, still never mind, just one of those things, I will have to see what I can do.
"Er" did you get my previous message, I have lost your e mail address, I did not put it in my contacts, I was looking forward to having a further chat mate, can you send it me or drop me an e mail and I will make sure I save it this time. Thanks, 48111
|
|
#4
8th January 2010, 12:16
|
||||
|
||||
|
The problem could be the motor brushes could it not?
They may well be worn out. When was the last time you oiled it? Without oil it may have siezed up or the motore being an old one could have burned out. I had a similar problem on my Hornby LYR 0-4-0St pug tank
__________________
"We can pay our debt to the past by putting the future in debt to us..."
|
|
#6
8th January 2010, 13:40
|
||||
|
||||
|
I think I may have got it!
On your models is there the copper strips con the connection between tender and engine? These may have come into contact and short circuited. This happened with the Tri- ang A1 pacific. On the other hand it might be a track originated problem so try a different loco ( a cheap one mind!) and see if the same thing occurs.
__________________
"We can pay our debt to the past by putting the future in debt to us..."
|
|
#7
8th January 2010, 17:19
|
||||
|
||||
|
If it was burning I fear it may be the armature. Good news they can be replaced. Be careful getting the brushes out.
Get in touch if you can via email I might have a spare one. Jack
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
