[John H-T]

A quick up update on progress. I have finished the basic wiring so it should be possible to run trains through to neighbouring modules. Will find out at Club on Wednesday!

All the droppers have been wired up to the bus which is copper tape round 3 sides of the board and also to the sockets for connecting to the next module.

I am trying a system used by another club member: wiring the droppers to copper clad sleepers stuck to the underside of the board and then from there to the bus. Should make trouble shooting easier.

Two photos: one of the wiring on the underside and one of the front board without stock so that the track layout is more obvious. Track still needs to be laid onto the back board, but I need to make the wagon turntable before I can do that.

The groups of three copper clad sleepers are for wiring the seep point motors, which will be the next task once the current wiring has been proved!

Best wishes,

John H-T.