[railwaybuddy]

hi all,
1) i have got a hornby elite unit and i have just bought a points and accessory decoder to use for my new layout, on my new layout i have 3 points left and 1 signal left which i want to put on the decoder, i have successfully programmed the decoder but i cant change the CV settings for 1 of the outputs to give a constant supply of electric to run the signal, i have followed all instructions been in contact with hornby (not much help) and i still cant change the settings. can anyone tell me if there is an easier way to change the settings???

2) i have also got hornby railmaster to use with my elite controller and laptop, i have sent my controller away to hornby for an update and have it back now. they said it works all fine and follow these procedures into install and make your controller work with your laptop. i have done everything they have said and my laptop still doesnt reconise the device (controller) (same problem as before the update)

does anyone know any solutions to my problems? or shall i go to the hornby factory in margate and show them the problems?